2 E4400-90363
Agilent Technologies ESG Family Feature Releases ESG Family Signal Generators
06/01 • GSM/EDGE BS Loopback BER,
Opt. 300 Rev. B
• Enhances the revision A to enable FER,
BLER, RBER, and sensitivity
measurements on an EDGE BTS or
transceiver module.
• New firmware revision supports the
EDGE fully coded uplink signal
generation according to the GSM 05.03
standard, version 8.3.0.
• The demodulator board and the BER
board have been replaced to support the
real-time demodulation and decoding of
the EDGE signal in addition to the GSM
signal.
ESG-D “B” with Opt. 300 and:
• Opt. UN8 with Option 202 Rev D
(Baseband Fuzzy board E4400-60070
and Flex DG board E4400-60154)
•Opt. UNA
Not available in ESG-DP
Not compatible with Opt. UND
≥ B.03.80
04/01 • Updated W-CDMA 3GPP TFCI Coding
to match Standard, Opt. 100
Opt. UND Rev.A or better (Dual Arb board
E4400-60069 or E4400-60187)
≥ B.03.75
• Enhanced the ESG with the ability to
support Signal Studio software
• Corrects recent erroneous reporting
of configuration Error 617
All ESG Series
02/01 Updated Revision Numbers for Fully
Coded 3GPP W-CDMA personality for
user equipment (downlink) and base station
(uplink) testing, Opt. 200. Based on the
following 3GPP Technical Specifications:
3G TS 25.101 V3.5 (2000-12) for Reference
Measurement Channels,
3G TS 25.101 V3.3 (2000-06) for user
equipment receiver characteristics testing,
and
3G TS 24.141 V3.4 (2000-12) for base station
testing.
Added 64k UDI multiple block downlink
channel, per 3G TS 25.944 V3.3 (2000-12),
Opt. 200
Added UN3/4 time delay compatible GSM
Gaussian filter, Opt. UN8
ESG-D “B” with Opt. UN8 Rev. C or better
(Baseband Fuzzy board E4400-60070 and
Flex DG board E4400-60154)
≥ B.03.72
• Updated Revision Numbers for
W-CDMA 3GPP 3.4 12-00 for
Component Test, Opt. 100
• Added multicarrier random phase,
Opt. UND
• Added UN3/4 time delay compatible
GSM Gaussian filter, Opt. UND
Opt. UND Rev. A or better (Dual Arb board
E4400-60069 or E4400-60187)
Release
Date
Feature Minimum Hardware Required
Firmware
Required
Comments to this Manuals