Agilent Technologies 35670A Service Manual download pdf (Page 10)

10 Agilent 35670A Supplement

2 Installation and Verification Guide

Preparing the Analyzer for Use

To connect the analyzer to an external monitor

The External Monitor is a standard 15- pin miniature connector

that can interface with an external monitor. The monitor must

be compatible with the 49.74 kHz line rate, 61.6 Hz frame rate,

analog RGB signals, and TTL sync signals provided by the

Agilent 35670A.

1 Set the analyzer’s power switch to on (|).

2 Set the monitor’s power switch to on.

3 Connect the external monitor’s input cable to the analyzer’s

rear panel EXT MONITOR connector.

4 Press the following keys to enable external display mode:

[Disp Format]

[MORE]

[EXT MON ON OFF]

Page in original guide 2-13

Figure 2 Rear panel showing external monitor connector

Pin 1

Pin6

Pin 11

Pin 5

Pin 10

Pin 15

Number

Signal Name Pin

Number

Signal Name Pin

Number

Signal Name

1 red analog output 6 Ground 11 Not connected

2 green analog output 7 Ground 12 Not connected

3 blue analog output 8 Ground 13 TTL Horizontal Sync

4 not connected 9 Not connected 14 TTL Vertical Sync

5 Ground 10 Ground 15 Not connected

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 51 52

No comments

Agilent Technologies 35670A Service Manual Page 10