Agilent Technologies 34980A Service Manual download pdf (Page 8)

6 34980A Getting Started Guide

Installing a Module for Use with Terminal Blocks

All of the 34980A plug-in modules, except the RF and microwave modules, can be used with a

compatible terminal blocks (optional accessories 349

T). The optional terminal blocks provide screw

terminals or solder cup connections for your external wiring. If you plan to use an optional terminal block,

follow the procedure below.

Step 1a. Using a Pozidriv #1 screwdriver,

remove the panhead grounding screw

located between the module connectors.

Step 1b. Remove the two flathead screws

from the support sleeve.

Step 2. Fit the terminal block support

sleeve against the module so the openings

on the sleeve line up with the connectors

and the center screw hole as shown.

Step 3. Replace the panhead screw.

Then replace and tighten the two flathead

screws to secure the sleeve to the module.

Step 4. Install the module into a

mainframe slot until it fully seats with the

backplane connector. Using a Pozidriv #1

screwdriver, tighten the two screws to

secure the module in the mainframe.

Installation is now complete.

NEXT STEP:

Go to “Wiring and Installing

a Terminal Block” on page 7.

Module

ort Sleeve

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 27 28

No comments

Agilent Technologies 34980A Service Manual Page 8