Agilent Technologies N5181A/82A User Manual download pdf (Page 220)

210 Agilent N518xA, E8663B, E44x8C, and E82x7D Signal Generators Programming Guide

Creating and Downloading Waveform Files

Commands for Downloading and Extracting Waveform Data

FTP Procedures

There are three ways to FTP files:

• use Microsoft’s® Internet Explorer FTP feature

• use the PC’s or UNIX command window

• use the signal generator’s internal web server following the firmware requirements in the table

below

Using Microsoft’s Internet Explorer

1. Enter the signal generator’s hostname or IP address as part of the FTP URL.

ftp://<host name> or

ftp://<IP address>

2. Press Enter on the keyboard or Go from the Internet Explorer window.

The signal generator files appear in the Internet Explorer window.

3. Drag and drop files between the PC and the Internet Explorer window

Using the Command Window (PC or UNIX)

This procedure downloads to non- volatile memory. To download to volatile memory, change the file

path.

CAUTION Get and Put commands write over existing files by the same name in destination

directories. Remember to change remote and local filenames to avoid the loss of data.

NOTE If a filename has a space, quotations are required around the filename.

Always transfer the waveform file before transferring the marker file.

For additional information on FTP commands, refer to the operating system’s command

window help.

1. From the PC command prompt or UNIX command line, change to the destination directory for the

file you intend to download.

Signal Generator Firmware Version (Required

for Web Server Compatibility)

N518xA All

E44x8C ≥ C.03.10

E82x7D, E8663B All

1 2 ... 215 216 217 218 219 220 221 222 223 224 225 ... 365 366

No comments

Agilent Technologies N5181A/82A User Manual Page 220