Agilent Technologies 8133A Specifications download pdf (Page 40)

Chapter 3: Testing Logic Analyzer Performance

Configure the Logic Analysis System

1 Exit the logic analysis application (from the main menu, choose File→Exit)

and then restart the application. This puts the logic analysis system into its

initial state.

2 Disable all logic analyzers other than the analyzer under test.

a Select the Overview tab at the bottom of the main window.

b Click on each unused logic analyzer and select disable. Only the logic

analyzer to be tested should remain enabled.

3 Set up the bus and signals.

a From the Logic Analysis System main menu, select Setup→My

1691xA→Bus/Signal....

b In the Analyzer Setup window, choose the Threshold button for Pod 1.

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 103 104

No comments

Agilent Technologies 8133A Specifications Page 40