Agilent Technologies 8133A Specifications download pdf (Page 87)

Chapter 6: Replacing Assemblies

To replace the circuit board

1 Remove the logic analyzer cables using the “To remove the logic analyzer

cable” procedure on page 85.

2 Remove the four screws attaching the ground spring and back panel to the

circuit board, then remove the back panel and the ground spring.

3 Replace the faulty circuit board with a new circuit board. On the faulty

board, make sure the 2x15 (30-pin) ribbon cable is connected between J15

and J12.

4 Position the ground spring and back panel on the back edge of the

replacement circuit board. Install four screws to connect the back panel

and ground spring to the circuit board.

5 Install the logic analyzer cables using the procedure “To install the logic

analyzer cable” on page 86.

1 2 ... 82 83 84 85 86 87 88 89 90 91 92 ... 103 104

No comments

Agilent Technologies 8133A Specifications Page 87