Agilent Technologies Ininiium 9000 Specifications download pdf (Page 135)

Chapter 6: Replacing Assemblies

To remove and replace the acquisition board assembly

135

To remove and replace the acquisition board assembly

Use this procedure to remove and replace the acquisition board assembly. When necessary, refer to other

removal procedures. The graphics in this chapter are representative of the oscilloscope at the time of

this printing. Your unit may look different.

Disconnect the power cable and remove the rear oscilloscope cover as described in previous

sections.

2 Remove the screws show in Figure 6-34, Figure 6-35, Figure 6-36, and Figure 6-37 to remove

the sheet metal separating the motherboard compartment from the acquisition board

compartment.

1 2 ... 130 131 132 133 134 135 136 137 138 139 140 ... 165 166

No comments

Agilent Technologies Ininiium 9000 Specifications Page 135