Agilent Technologies E4438C Installation Guide download pdf (Page 12)

Getting Started

Overview of Getting Started

1-2

Overview of Getting Started

Agilent’s service support software allows fast and accurate testing of the Agilent E4438C ESG vector signal

generator. This chapter describes how to install, configure, and run service support software so that you can

adjust and test an Agilent E4438C ESG vector signal generator to meet specifications.

How to Proceed

First, review the rest of this section to learn about installing, configuring, and running service support

software. Next, refer to “Required Equipment” to learn about hardware and software requirements, or become

familiar with “Performance Tests” or “Adjustments”. If you need assistance, refer to the section on

“Contacting Agilent Technologies” on page 5-1.

To install, configure, and run this software, refer to and perform the steps in the following procedures:

1. “Confirming Equipment” on page 1-3

2. “Installing Service Support Software” on page 1-4

3. “Administering Service Support Software” on page 1-8

4. “Running Service Support Software” on page 1-22

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 139 140

No comments

Agilent Technologies E4438C Installation Guide Page 12