Agilent Technologies N1022A User's Guide download pdf (Page 11)

Safety Information

Warning To avoid personal injury and to prevent fire or damage to this product or products

connected to it, review and comply with the following safety precautions. Be aware that

if you use this probe assembly in a manner not specified, the protection this product

provides may be impaired.

Handle Probe Tips / Accessories Carefully

Some of the probe tips / accessories are very sharp (the spring tips, for example). You

should handle these with care to avoid personal injury.

Use Only Grounded Instruments

Do not connect the probe’s ground lead to a potential other than earth ground. Always

make sure the probe and the oscilloscope are grounded properly.

Connect and Disconnect Properly

Connect the probe to the oscilloscope and connect the ground lead to earth ground before

connecting the probe to the circuit under test. Disconnect the probe input and the probe

ground lead from the circuit under test before disconnecting the probe from the

oscilloscope.

Observe Probe Ratings

Do not apply any electrical potential to the probe input which exceeds the maximum

rating of the probe. Make sure to comply with the voltage versus frequency derating

curve found in this manual.

Keep Away From Live Circuits

Avoid open circuitry. Do not touch connections or components when power is present.

Indoor Use Only

Do not operate in wet/damp environments. Keep product surfaces dry and clean.

Do Not Operate With Suspected Failures

Refer to qualified service personnel.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 40 41

No comments

Agilent Technologies N1022A User's Guide Page 11