Agilent Technologies N1022A User's Guide download pdf (Page 7)

Characteristics and Specifications

Characteristics and specifications for the N2795A/N2796A Single-ended Active Probes

are shown below. The probe / oscilloscope should be warmed up for at least 20 minutes

before any testing and the environmental conditions should not exceed the probe’s

specified limits.

Electrical Characteristics

Attenuation ratio (@ DC) N2795A: 10:1 +/- 0.5%

N2796A: 10:1 +/- 0.5%

Bandwidth (-3 dB)* N2795A: 1 GHz

N2796A: 2 GHz

Probe Risetime (calculated,

10%-90%)

N2795A: 350 ps

N2796A: 175 ps

Input Dynamic Range N2795A: -8V to +8V (DC or Peak AC)

N2796A: -8V to +8V (DC or Peak AC)

Input Resistance* N2795A: 1 MW +0%, -2.5%

N2796A: 1 MW +0%, -2.5%

Non-destructive Max Input

Voltage

N2795A: -20V to +20V

N2796A: -20V to +20V

Offset Range N2795A: +/- 8V

N2796A: +/- 12 V

DC Offset Error (Output Zero) N2795A: < +/- 1 mV

N2796A: < +/- 1 mV

Flatness (both models) Typical 0.4 dB (100 kHz - 100 MHz)

Typical 0.6 dB (100 MHz - 500 MHz)

Typical 0.8 dB (500 MHz - 1 GHz)

Typical 1.3 dB (1 GHz - 2 GHz)**

Input Capacitance N2795A: 1 pF

N2796A: 1 pF

Probe Noise (referred to input) N2795A: < 1 mVrms

N2796A: < 1 mVrms

Output Impedance N2795A: 50 W

N2796A: 50 W

Internal Power Agilent AutoProbe Interface from Scope

(InfiniiVision and Infiniium models)

*Denotes warranted specification after 20 minute warm-up, all others typical

**N2796A only

1 2 3 4 5 6 7 8 9 10 11 12 ... 40 41

No comments

Agilent Technologies N1022A User's Guide Page 7