Agilent Technologies E6392B User's Guide download pdf (Page 89)

88 Chapter 3

Screen Reference

MANUAL TEST (Synchronous Mode)

Talk/RF Test Measuring Screen

While the Talk/RF Test step is blinking as shown in Figure 3-24, you can make

measurements on each test item before releasing the mobile. If you select a test

item column with the CURSOR CONTROL knob, the corresponding measuring

screen is displayed making real-time measurements.

Figure 3-24 Talk/RF Test Measuring Screen

Softkey Menu

o BS Release: Executes Call End from the Test Set showing the operation

message “Processing...”.

o MS Release: Shows the operation message “Executing a call end from the

mobile.” for a user to take action.

NOTE For Call End from the mobile, both of pressing the MS Release softkey and

executing the call end from the mobile are required.

o Abort: Returns to the MANUAL TEST: Stand-by screen, and then to the

initial screen with function modes.

NOTE After pressing the Abort softkey, execute call end from the mobile; otherwise the

call processing may be failed at the next measurement.

Explanation

While the Talk/RF Test step is blinking, one of the test items can be selected by

rotating and pressing the CURSOR CONTROL knob, and its measurements are

made in a real-time manner showing the changes in characteristics of the mobile

under test.

In this state, DC Current under the test item table shows the dc current consumed

at the Talk/RF Test step. RX Quality and RX Level are also shown in this place.

Procedure to obtain the Measuring screens

Step 1. Place the blinking cursor at one of the test items by rotating the CURSOR

CONTROL knob.

1 2 ... 84 85 86 87 88 89 90 91 92 93 94 ... 205 206

No comments

Agilent Technologies E6392B User's Guide Page 89