Agilent Technologies Agilent 35900E Installation Guide

Setting up a LAN Instrument Network Installation Guide

Setting up a LAN Instrument Network 10 Setting IP addresses from instrument keypad When entering an IP address at an instrument, be sure it is cor

Setting up a LAN Instrument Network 11 4. Scroll to SM and press [Mode/Type]. Scroll to the appropriate subnet mask from the list of modes and pr

Setting up a LAN Instrument Network 12 The initial installation requires that you connect the software keypad directly to the GC using this addres

Setting up a LAN Instrument Network 13 Assigning IP addresses to instruments with Jet Direct cards IP addresses for the 6890A, 6890 Plus, 35900E,

Setting up a LAN Instrument Network 14 6. Add the instrument a. Follow Start > Programs > Agilent BootP Service > Edit BootP Settings

Setting up a LAN Instrument Network 15 Initialization Mode Selection The following initialization modes are selectable: NOTE Compared to the G1

Setting up a LAN Instrument Network 16 Since the default IP address is a local address, it will not be routed by any network device. Thus, the PC

Setting up a LAN Instrument Network 17 Figure 6: Telnet command where <IP address> is a nonroutable unique local address that you assign or

Setting up a LAN Instrument Network 18 Figure 8: Telnet information Information about the card Product id, firmware revision s, MAC address Init

Setting up a LAN Instrument Network 19 Verify communications using the ping command The ping command verifies communications across a TCP/IP conne

Notices © Agilent Technologies, Inc. 2010 No part of this manual may be reproduced in any form or by any means (including electronic storage and retr

Setting up a LAN Instrument Network 20 Install the Jet Direct Card Accessories (if required) JetDirect Card accessory for the 6890A and 6890 Plus

Setting up a LAN Instrument Network 21 JetDirect Card connection of the 6850 and 35900E to the Chemstation The Jet Direct Accessory Kit for the 68

Setting up a LAN Instrument Network 22 Chemstation LAN Installation Checklist  Determine configuration – Isolated or Site LAN.  Determine Inst

Edition G2070-90605 Revision 1 ©Agilent Techologies, Inc. Printed in USA, June 2010

Setting up a LAN Instrument Network 3 Contents Identifying the Required Instrument LAN ...5 Configuring yo

Setting up a LAN Instrument Network 4

Setting up a LAN Instrument Network 5 Identifying the Required Instrument LAN An instrument LAN consists of one or more data system computers and

Setting up a LAN Instrument Network 6 Figure 2: Network multiple instruments on a LAN Site LAN You can attach the workstation and all of the labo

Setting up a LAN Instrument Network 7 Windows Vista: Select Start > Control Panel > Network and Sharing > Manage Network Connections. Win

Setting up a LAN Instrument Network 8 Instruments on the LAN Each LAN instrument requires a unique IP address on the same subnet as the ChemStatio

Setting up a LAN Instrument Network 9 Instrument Firmware Requirements Table 1: Instrument Requirements Instrument Type Model Supported instru