1 Disconnect the power cord.2 Remove the outer cover from the Agilent 34970A.To remove the cover from the instrument, follow the procedures shownin
4 Install the internal DMM circuit board into the chassis.Position the internal DMM circuit board inside the instrument chassisby tilting it at an a
6 Twist the internal DMM input cable.Twist the internal DMM input cable (labeled P101) at least one full turnbefore plugging it into the backplane c
9 Modify the Labeling on the Rear Panel.If you originally ordered the 34970A without the internal DMM, a solidblack circle should be visible above t
Comments to this Manuals