Agilent Technologies N8201A Service Manual download pdf (Page 15)

Security Features 1

Agilent N8211A/N8212A Performance Upconverter Synthetic Instrument Module, 250 kHz to 20/40 GHz 15

SCPI Commands

Security Commands

:SECurity:ERASeall

:SYSTem:SECurity:ERASall

This command removes all user files, table editor files, flatness correction files, and

baseband generator files. This command differs from the :DELete:ALL command,

which does not remove table editor files.

:SECurity:LEVel NONE|ERASe|OVERwrite|SANitize

:SYSTem:SECurity:LEVel NONE|ERASe|OVERwrite|SANitize

:SYSTem:SECurity:LEVel?

This command selects the secure mode and enables you to select a level of security.

:SECurity:LEVel:STATe must be set to ON to activate the selected security level,

and power must be cycled to perform the selected cleaning operation. Selecting NONE

will preset the upconverter to the factory state. For other cleaning operation descriptions,

see SECurity:ERASall, SECurity:OVERwrite, and SECurity:SANitize.

Remarks

:SECurity:LEVel:STATe must be set to ON to activate the selected security level.

:SECurity:LEVel:STATe ON|OFF|1|0

:SYSTem:SECurity:LEVel:STATe ON|OFF|1|0

:SYSTem:SECurity:LEVel:STATe?

When this command is enabled (1) it activates the selected security level. When disabled

(0) it executes the selected security level. Once the secure mode is entered, the security

level can only be increased.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 29 30

No comments

Agilent Technologies N8201A Service Manual Page 15