Getting Started 1
U3401A User’s and Service Guide 23
Performing resistance/continuity measurements
• Six ranges: 500.00 W, 5.0000 kW, 50.000 kW, 500.00 kW, 5.000 MW,, 50.000 MW,
• Measurement method: Two-wire ohms, open circuit voltage limited to <5 V
• Input protection: 500 V on all ranges
1 Press .
2 Connect the red and black test leads to the input terminal as shown in
Figure 1- 15.
3 Probe the test points (by shunting the resistor) and read the display.
In autoranging mode, the multimeter automatically selects the
appropriate range and the measurement is displayed.
Figure 1-15 Resistance /continuity terminal connection and display
Disconnect circuit power and discharge all high-voltage capacitors before measuring
resistance, or testing circuit continuity, to avoid damaging the multimeter or the device
under test.
Comments to this Manuals