Agilent Technologies All Troubleshooting Guide download pdf (Page 188)

Data Organization 21

Data Analysis 3

Data Analysis

With this toolset, you can jump to the beginning or end of the Navigation

Table, step on to next or previous run, automatically step through the runs,

and stop automatic stepping.

A different way to analyze your data is to “Reprocess” a complete sequence.

During this process, all runs are reanalyzed in the sequence context, i.e. the

calibration tables of the sequence methods are updated in the case of

calibration runs, multipliers, amounts etc. can be changed in the sequence

table, new methods can be added to the sequence container, etc. For

reprocessing, the Navigation Table provides the following toolset:

Note that the reprocessing icons in the Navigation Table are available only for

sequence data generated with ChemStation B.02.01 and higher. For Single Run

data, for data generated prior to B.02.01, and for data acquired while Unique

Folder Creation is switched off (see Chapter 4, “Workflow with Unique Folder

Creation switched off”), reprocessing in Data Analysis is not accessible.

Sequences acquired prior to B.02.01 need to be reprocessed in “Method and

Run Control”, defining the sequence parameter “parts of method to run” to

“reprocess only”. For sequences generated with ChemStation B.02.01 and

higher, the reprocessing option in Method and Run Control has been removed

(see Figure 8 on page 22), and the Navigation Table offers reprocessing as a

Data Analysis Task.

Figure 7 Sequence Reprocessing Toolset of the Navigation Table

1 2 ... 183 184 185 186 187 188 189 190 191 192 193 ... 210 211

No comments

Agilent Technologies All Troubleshooting Guide Page 188