Agilent Technologies All Troubleshooting Guide download pdf (Page 193)

26 Data Organization

3 Data Analysis

Data Analysis: Data Review

This means that each time you load a run from the Navigation Table, the

sequence method corresponding to the run’s sequence line is loaded.

Once the data review has been completed, it may be necessary to reprocess the

complete sequence in order to apply the method changes not only on a

run-per-run base, but also in the complete sequence context (including

calibration table updates etc.).

Load “Individual Method from Data File (DA.M)”

The review setting “Individual Method from Data File (DA.M)” (see Figure 12),

should be used, if you want to load the individual DA.M automatically along

with the corresponding data file, when this file is loaded using the navigation

table. When you change a method and then load the next run, you will be

asked to save your method changes, because you load a new method: the DA.M

of the next run.

Various workflows may require that you always review data with the

individual data analysis method (DA.M) loaded. For example, when all runs

are loaded with DA.M, the analysis results are the same as during acquisition

Figure 11 Load the Sequence Method for Data Review

1 2 ... 188 189 190 191 192 193 194 195 196 197 198 ... 210 211

No comments

Agilent Technologies All Troubleshooting Guide Page 193