Agilent Technologies All Troubleshooting Guide download pdf (Page 191)

24 Data Organization

3 Data Analysis

Data Analysis: Data Review

The remainder of this section specifies which method is loaded during data

review when a run is loaded from the Navigation Table. They only apply to

data review, but not to reprocessing. The following separate option sets are

available for sequence runs and single runs:

Keep “Current Method”

The review setting “Current Method” should always be used when you want to

use the method that is currently loaded. In this respect, for data review the

current method remains irrespective of which single run data file or sequence

container file is loaded. This setting should be used for method development,

to create a calibration table or other updates etc. For example, you run a

sequence with runs of different concentrations in order to optimize

integration parameters, and afterwards build the calibration table. As these

changes in data analysis parameters must be available for all future

acquisition runs, you have to apply them to the master method. In order to do

this, you select the option “Current Method” in the Preferences dialog, see

Figure 10. This ensures that, for each run loaded, the same method is always

kept in memory.

Table 1 Data Review Options for Sequence and Single Run Data

Method used for review of sequence data Method used for review of single run data

Current Method Current Method

Sequence Method Individual method from data file (DA.M)

Individual method from data file (DA.M)

1 2 ... 186 187 188 189 190 191 192 193 194 195 196 ... 210 211

No comments

Agilent Technologies All Troubleshooting Guide Page 191