Agilent Technologies 4294A Instruction Manual download pdf (Page 189)

100

101

Chapter 7 181

Setting Up the Display of Measurement Results

Trace-based Comparison and Calculation

7. Setting Up the Display of

Measurement Results

In the table above, DATA represents the current measurement data while MEM represents

the data captured by pressing the

DATA ® MEMORY key.

Step 10. Start testing the DUT to obtain the measurement data for comparison or calculation with

the reference measurement data you stored into the memory trace in step 5 (if the sweep

cycle is in the hold state, you can restart the measurement by pressing the

[Trigger] key).

NOTE If the number of measuring points you specify in step 10 is different than the measurement

data stored in the memory trace, then the memory trace is cleared and the data trace will

display only the measurement data (this is equivalent to pressing the

DATA key).

The

DELTA % key is not available when your measurement parameter is COMPLEX Z-Y.

Conversely, the

DATA/MEM key is available only when your measurement parameter is

COMPLEX Z-Y.

If you specify an offset value, the data trace displays the result of subtracting the offset

value from the specific type of data that corresponds to the display option you selected in

step 9. (For more information on setting an offset value, refer to “Subtracting an Offset

Value” on page 184.)

(Hidden) MEM MEMORY

DATA MEM DATA and MEMORY

DATA - MEM (Hidden) DATA-MEMORY

(Hidden) DELTA %

DATA/MEM (Hidden) DATA/MEM

Data trace Memory trace Press:

DATA MEM–

MEM

------------------------------------

100´

1 2 ... 184 185 186 187 188 189 190 191 192 193 194 ... 468 469

Comments to this Manuals

No comments

Agilent Technologies 4294A Instruction Manual Page 189

Comments to this Manuals

Related products and manuals for Multimeters Agilent Technologies 4294A