Agilent Technologies 4294A Instruction Manual download pdf (Page 452)

444 Appendix C

Error messages

Suffix not allowed

A suffix error. An error other than -131 to -139 occurs in the notation of a suffix.

-138 Suffix not allowed

A suffix is added to a numeric value element to which no suffix should be added.

-134 Suffix too long

The suffix is too long. The suffix contains the notation of 12 characters or more. (Refer to

IEEE488.2,7.7.3.4.)

-102 Syntax error

There is a command or data type that cannot be recognized. For example, although the

4294A does not accept any strings, a string is received.

-310 System error

One of the “system errors” defined for the 4294A occurred.

87 THETA MEASUREMENT NOT SELECTED

When the setting of the phase (q) is not active as a measurement parameter, you attempt to

execute a command to set the phase unit (PHAU DEG or PHAU RAD) or a command to set

the phase expansion display (EXPP ON or EXPP OFF) and, as a result, the command is

ignored. The active status of the phase (q) setting means:

•|Z|-q or |Y|-q is selected as a measurement parameter, and trace B is active.

• COMPLEX Z-Y is selected as a measurement parameter, and the display format is

POLAR (polar coordinates display format) for the selected active trace.

Before executing a command to set the phase unit or a command to set the phase expansion

display, perform one of the above settings.

-124 Too many digits

The number of digits of the mantissa of the decimal value data element exceeds 255 except

when there are preceding 0s. (Refer to IEEE 488.27.7.2.4.1.)

64 TOO MANY SEGMENTS

You attempt to add segments to the limit line table at a quantity that exceeds the maximum

number (18). The number of segments you can set in the limit line table is up to 18.

77 TOO MANY SEGMENTS OR POINTS

During the editing of the list sweep table, you attempt to set a value that exceed the

maximum number of segments (18), the maximum number of points per segment (201), or

the maximum number of total points in all segments (801). Set the number of segments or

the number of points to a value that does not exceed the maximum value.

54 TOO MUCH DATA

When data is sent from the controller to the Agilent 4294A in the FORM2, FORM3, or

FORM5 data transfer format, the amount of the sent binary data is too large, or data items

exceed the number of points (NOP) set. Be sure to correctly set the data to be sent or the

number of points of the Agilent 4294A.

-223 Too much data

1 2 ... 447 448 449 450 451 452 453 454 455 456 457 ... 468 469

No comments

Agilent Technologies 4294A Instruction Manual Page 452