Agilent Technologies 4294A Instruction Manual download pdf (Page 266)

258 Chapter 8

Analysis and Processing of Result

Set a limit to the trace and make pass/fail evaluation

• Press the step keys ([][¯]) to set the desired value.

This setting allows a new start value to be written for the start value string (START) on the

line of the segment being edited in the limit line table.

NOTE Instead of directly entering the start value of the segment according to Steps 8 and 9, you

may also follow the procedure below:

(1) Press the

[Entry Off] key.

(2) Move the main marker to the position of the segment start value using the rotary knob

(

m) or the step keys [][¯]).

(3) Key operations of

more 1/3 - more 2/3 - MKR ® START allow the sweep parameter

value at the position of the main marker to be substituted into the segment start value.

After setting in this order, press the

more 3/3 key to go back to the first page of the

Segment Edit menu.

Step 10. Press the

UPPER LIMIT key or MIDDLE VALUE key. This displays the upper value or

middle value of the limit range at the start point in the set parameter value field in the upper

left area of the screen.

Step 11.

Set the upper or middle value by one of the following methods using the keys inside the

Entry block:

• Enter the value using the numeric keys (

[0] through [9], [-] and [.]) and then press a unit

key (

[G/n], [M/m], [k/m], or [´1]).

• Turn the rotary knob (

m) to the right or left to set the value.

• Press the step keys ([][¯]) to set the value.

This setting allows a new upper limit or middle value to be written for the upper

value/middle value string at the start point on the line of the segment being edited in the

limit line table.

NOTE Instead of directly entering the upper or middle value of the segment according to steps 10

and 11, follow the procedure below:

(1) Press the

[Entry Off] key.

(2) Move the main marker to the position of the segment start point using the rotary knob

(

m) or the step keys ([][¯]).

(3) Key operations of

more 1/3 - more 2/3 - MKR ® VALUE START allow the

measurement parameter value at the start point of the trace to be substituted into the limit

range center value. After setting in this order, press the

more 3/3 to go back to the Segment

Edit menu (1/3).

Step 12. Press the

LOWER LIMIT key if the limit range was first set by the upper limit value. Press

the

DELTA LIMIT key if it was first set by the center value. The lower limit of the limit

range at the start point or the differential value limit (ranges of upper limit value and lower

limit value) is displayed in the set parameter value area on the upper left of the screen.

Step 13. Set the lower limit value or limit differential value by one of the following methods using

the keys inside the Entry block:

1 2 ... 261 262 263 264 265 266 267 268 269 270 271 ... 468 469

Comments to this Manuals

No comments

Agilent Technologies 4294A Instruction Manual Page 266

Comments to this Manuals

Related products and manuals for Multimeters Agilent Technologies 4294A