Agilent Technologies 4294A Instruction Manual download pdf (Page 298)

290 Chapter 8

Analysis and Processing of Result

Save and Recall the Agilent 4294A Internal Data

The extension ".TIF" is automatically added to the file name of the file you saved.

If you try to perform the GRAPHICS save operation for a screen such as a list sweep table

and limit line table during edit with the

[Save] key, pressing the [Save] key finishes the

edit mode and changes the screen and you cannot save a desired display screen. In this

case, do not use the

[Save] key and send the GPIB command for save (SAVDTIF) via

GPIB or LAN to the 4294A or use the get command of the FTP (File Transfer Protocol)

function to acquire the screen display file "screen.tif" on the 4294A's dynamic data disk via

LAN into an external computer. For how to use GPIB, LAN, and the FTP function, see

"Programming Guide."

Overwrite on the file to be saved

Using the STATE, DATA and GRAPHICS save functions, you can write new data over the

saved data. The contents to be saved by overwriting (STATE, DATA and GRAPHICS save)

are identified by the extension attached to the name of the overwritten the file. The state of

selection of the contents to be saved by the DATA saving function conform to that of the

file to be overwritten.

Step 1. Press the

[Save] key to display the Save menu.

Step 2. Press the STORE DEV [ ] key to display the Storage Device menu.

Step 3. Select the Agilent 4294A storage device.

NOTE When using the floppy disk drive, make sure a disk is first inserted in the drive.If the

floppy disk is set to “Write Protect,” the data cannot be saved. Set the disk to “Write

Enable” before using it.

The storage device selection using

[System] - IBASIC - more 1/3 - MASS STORE [ ] is

applicable when using the storage devices of the Agilent 4294A through the HP Instrument

BASIC function. It is different from the storage device selection using the

STORE DEV [ ]

key here. However, the storage devices themselves are the same.

Step 4. Press the

return key to return to the Save menu. The selected storage device is displayed in

the

[] box of the key label of the STORE DEV [ ] key.

Step 5. Press the

RE-SAVE key. Then the contents of the selected storage device are read and the

File Select menu is displayed. The first through fourth softkey labels from the top in the

Storage device Key operation

Floppy disk drive

FLOPPY

Volatile memory disk MEMORY

Non-volatile memory disk (flash memory) FLASH MEMORY

Softkey label Selected storage device

STORE DEV [FLOPPY] Floppy disk drive

STORE DEV [MEMORY] Volatile memory disk

STORE DEV [FLASH] Non-volatile memory disk (flash memory)

1 2 ... 293 294 295 296 297 298 299 300 301 302 303 ... 468 469

Comments to this Manuals

No comments

Agilent Technologies 4294A Instruction Manual Page 298

Comments to this Manuals

Related products and manuals for Multimeters Agilent Technologies 4294A