Agilent Technologies 4294A Instruction Manual download pdf (Page 417)

Appendix B 409

Key Definitions

Softkeys displayed by pressing the [System] key

B. Key Definitions

Table B-83 Limit line edit (Edit Limit) menu

Key operation: [System] - LIMIT TEST - EDIT LIMIT LINE

Softkey Function GPIB command

SEGMENT From the limit line table, specifies a segment number to be edited. The currently

specified segment is indicated by the pointer (>) on the table. You can change the

specified segment number using the ENTRY block keys (numeric key, rotary

knob, [][¯] keys) on the front panel. If there is no segment in the limit line table

(“EMPTY” is displayed at the top of the table), add/edit segments using the

EDIT key or ADD key.

LIMSEGM <value>

EDIT ä For the segment indicated by the current pointer (enters into the edit mode. In the

segment edit mode, the menu changes to Table B-84, “Segment edit (Edit Limit)

menu (1/3),” on page 409. If there is no segment in the limit line table

(“EMPTY” is displayed at the top of the table), a preset segment is added as

substitution and the edit mode is invoked.

LIMSEDI

DELETE Deletes the segment indicated by the current pointer (>). LIMSDEL

ADD ä Inserts a segment whose contents are the same as the segment indicated by the

current pointer (>) after the segment and enters the segment edit mode. In the

segment edit mode, the menu changes to Table B-84, “Segment edit (Edit Limit)

menu (1/3),” on page 409. If there is no segment in the limit line table

(“EMPTY” is displayed at the top of the table), a preset segment is added as

substitution and the edit mode is invoked.

LIMSADD

CLEAR LIST ä Displays Table B-87, “List deletion (Clear List?) menu,” on page 412. LIMCLEL

done Finishes the editing of the limit line table, replaces the table before the editing

with the new table, and stores it. Also, returns to Table B-82, “Limit test (Limit

Test) menu,” on page 408.

LIMEDONE

cancel Cancels the editing of the limit line table and returns to Table B-82, “Limit test

(Limit Test) menu,” on page 408. The limit line table before the editing remains

unchanged.

(N/A)

Table B-84 Segment edit (Edit Limit) menu (1/3)

Key operation: [System] - LIMIT TEST - EDIT LIMIT LINE - EDIT

[System] - LIMIT TEST - EDIT LIMIT LINE - ADD

Softkey Function GPIB command

START Sets the sweep start value of the segment. LIMSTAR <value>

UPPER LIMIT Sets the upper limit of the measured value at the sweep start point of the

segment

. Be sure to set both the upper limit and the lower limit. If an upper

limit is not required, set an extremely large value (for example, 1G) as the upper

limit. If you set the upper limit smaller than the lower limit, both limits are set to

the newly entered value automatically.

LIMUSTAR <value>

LOWER LIMIT Sets the lower limit of the measured value at the sweep start point of the

segment

. Be sure to set both the upper limit and the lower limit. If a lower limit

is not required, set an extremely small value (for example, -1G) as the lower

limit. If you set the lower limit greater than the upper limit, both limits are set to

the newly entered value automatically.

LIMLSTAR <value>

1 2 ... 412 413 414 415 416 417 418 419 420 421 422 ... 468 469

Comments to this Manuals

No comments

Agilent Technologies 4294A Instruction Manual Page 417

Comments to this Manuals

Related products and manuals for Multimeters Agilent Technologies 4294A