Agilent Technologies 4294A Instruction Manual download pdf (Page 451)

Appendix C 443

Error messages

REDUCE OSC LEVEL

C. Error messages

error occurs, for example, when data in a file to be read out is destroyed or when an

extension for a file name does not match with the contents of the file.

134 REDUCE OSC LEVEL

The oscillator level is considerably higher than the measured |Z| (absolute value of

impedance) of the DUT, causing increased nonlinear measurement error that cannot be

ignored. This message is displayed when the oscillator level is set to greater than 0.5 V

while |Z| of the DUT is smaller than 48 W. To avoid this error, set the oscillator level below

0.5 V.

110 SAVE ERROR

When saving a file, anomalies in the storage media are detected. For example, if you

attempt to save a file on a floppy disk, it may be damaged. Check that there is no problem

with the storage media.

90 SCALE PARAMETER NOT VALID

You attempt to set a display scale not available for the selected display format and, as a

result, the command is ignored. For example, when the log scale (command: FMT LOGY)

is selected as the display format, you attempt to perform the SCALE/DIV setting

(command: SCAL <value>).

102 SEARCH RANGE TYPE IS NOT SEGMENT

Although in the list sweep all segments (entire sweep range) are specified as the search

range (command: SEARNG FULL), you attempt to execute a command to specify a

certain segment as a search target (SEGMNUM <value>) and, as a result, the command is

ignored. Before executing the search function by specifying a certain list sweep segment,

set the search range to a single segment (command: SEARNG SEGMENT).

101 SEARCH WIDTH OFF

When the band width function is off, you attempt to execute a command to search the

cutoff point on the trace (WIDSIN or WIDSOUT) and, as a result, the command is ignored.

Before executing the cutoff point search of the band width function, turn on the band width

function (command: WIDT ON).

-330 Self-test failed

The result of the self-test is failure. Contact your local Agilent Technologies sales office or

service center, or refer to the service manual.

-221 Setting conflict

A program data element complying with the syntax standard is analyzed but the 4294A

cannot execute it at present.

-150 String data error

An error not described by error numbers from -151 to -159 occurs during the syntax

analysis of a string data element.

-158 String data not allowed

A string data element is received where the 4294A does not accept any string data element.

-130 Suffix error

1 2 ... 446 447 448 449 450 451 452 453 454 455 456 ... 468 469

Comments to this Manuals

No comments

Agilent Technologies 4294A Instruction Manual Page 451

Comments to this Manuals

Related products and manuals for Multimeters Agilent Technologies 4294A