Agilent Technologies N8201A Service Manual download pdf (Page 165)

SCPI Basics 6

Agilent N8211A/N8212A Performance Upconverter Synthetic Instrument Module, 250 kHz to 20 / 40 GHz 165

This command has :LIST in the command syntax. This denotes that "SWEEP_1" will be

saved in the :List file type location as a list type file.

The following examples demonstrate a command where Format 2 applies:

This command cannot distinguish which file type "FLATCAL" belongs to without the file

type extension (@USERFLAT). If this command were executed without the extension, the

command would assume the file type was Binary.

The following examples demonstrate a command where format 3 applies:

This command gives the directory path name where the file "FLATCAL" is stored.

A the number of decimal digits to follow in B.

B a decimal number specifying the number of data bytes in C.

C the binary waveform data.

Refer to Ta b l e 1 6 on page 191 for a listing of the file systems and types. The entries under

file type are used in the directory path.

MSUS (Mass Storage Unit Specifier) Variable

The variable "<msus>" enables a command to be file type specific when working with

user files. Some commands use it as the only command parameter, while others can use it

in conjunction with a file name when a command is not file type specific. When used with a

file name, it is similar to Format 2 in the“File Name Variables" on page 164. The difference

is the file type specifier (msus) occupies its own variable and is not part of the file name

syntax.

Command Syntax with the file name variable

:MMEMory:COPY "<filename>","<filename>"

Command Syntax with the file name

:MMEMory:COPY "FLATCAL@USERFLAT","FLAT_2CAL@USERFLAT"

Command Syntax with the file name variable

:MMEMory:DATA "/USER/BBG1/WAVEFORM/<file name>",#ABC

Command Syntax with the file name

:MMEMory:DATA "/USER/BBG1/WAVEFORM/FLATCAL",#ABC

1 2 ... 160 161 162 163 164 165 166 167 168 169 170 ... 331 332

No comments

Agilent Technologies N8201A Service Manual Page 165