Agilent Technologies N8201A Service Manual download pdf (Page 310)

310 Agilent N8211A/N8212A Performance Upconverter Synthetic Instrument Module, 250 kHz to 20 / 40 GHz

9 Analog Commands

*RST +2.00000000E−006

Range 70 nS – 42 S

:PULM:INTernal[1]:PERiod:STEP[:INCRement]

Supported Option UNU or UNW

[:SOURce]:PULM:INTernal[1]:PERiod:STEP[:INCRement]<val><units>|MAXimum|MI

Nimum|DEFault

[:SOURce]:PULM:INTernal[1]:PERiod:STEP[:INCRement]?

Sets the step value for the internal pulse period using the variable <val><units>.

The step value, set with this command, is used with the UP and DOWN choices available in

the “:PULM:INTernal[1]:PERiod" on page 309 command.

The step value set with this command is not affected by a power-on, preset, or *RST

command.

Example

:PULM:INT:PER:STEP .1S

The example sets the square wave pulse rate to 100 mS.

*RST +1.00000000E-006

Range 10 nS – 42 S

:PULM:INTernal[1]:PWIDth

Supported Option UNU or UNW

[:SOURce]:PULM:INTernal[1]:PWIDth <num><time_suffix>|UP|DOWN

[:SOURce]:PULM:INTernal[1]:PWIDth?

Sets the pulse width for the internally generated pulse signal.

This command sets the pulse width for the internally-generated pulse modulation using the

variables <num><time_suffix>. The command, used with the UP|DOWN parameters, will

change the pulse width by a user-defined step value. Refer to the

“:PULM:INTernal[1]:PWIDth:STEP" on page 311 command for setting the value associated

with the UP and DOWN choices.

If the entered value for the pulse width is equal to or greater than the value for the pulse

period, the pulse width changes to a value that is less than the pulse period.

1 2 ... 305 306 307 308 309 310 311 312 313 314 315 ... 331 332

No comments

Agilent Technologies N8201A Service Manual Page 310