Agilent Technologies N8201A Service Manual download pdf (Page 247)

Basic Function Commands 8

Agilent N8211A/N8212A Performance Upconverter Synthetic Instrument Module, 250 kHz to 20 / 40 GHz 247

:LIST:MODE

Supported All

[:SOURce]:LIST:MODE AUTO|MANual

[:SOURce]:LIST:MODE?

Sets the operating mode for the current list or step sweep.

AUTO Enables the selected sweep type to perform a sweep of all points.

MANual Enables you to select an individual sweep point to control the RF output

parameters. For more about selecting a sweep point, see“:LIST:MANual" on page 246.

Example

:LIST:MODE AUTO

The example sets the mode to automatic.

*RST AUTO

:LIST:POWer

Supported All

[:SOURce]:LIST:POWer <val>{,<val>}

[:SOURce]:LIST:POWer?

Sets the amplitude for the current list sweep points.

The setting enabled by this command is not affected by power-on, preset, or *RST.

During an amplitude sweep operation, N8211A/N8212As with Option 1E1 protect the step

attenuator by automatically switching to attenuator hold mode (OFF). The attenuator locks

at its current setting and the amplitude sweep range is limited to 40 dB. The maximum

number of points is 1601.

Example

:LIST:POW .1,.2,.1,.3,.1,-.1

The example sets the power level for a six point sweep list.

Range See “[:LEVel][:IMMediate][:AMPLitude]" on page 269.

1 2 ... 242 243 244 245 246 247 248 249 250 251 252 ... 331 332

No comments

Agilent Technologies N8201A Service Manual Page 247