Agilent Technologies B2902 Service Manual download pdf (Page 109)

Agilent B2900 SCPI Command Reference, Edition 2 3- 5

Common Commands

*ESE

This command sets the bits of the Standard Event Status Enable register. This

command programs the Standard Event Status Enable register bits. The

programming determines which events of the Standard Event Status Enable register

are allowed to set the ESB (Event Summary Bit) of the Status Byte register. A 1 in

the bit position enables the corresponding event. For the SCPI status system, see

“Status System Diagram” on page 1-19.

Syntax *ESE enable_number

*ESE?

Parameter enable_number Decimal value that is the sum of the binary-weighted values for

the desired bits, hexadecimal, octal, or binary value. Parameter

data type is NR1 or NDN.

Query response enable_number <newline><^END>

enable_number is the sum of the binary-weighted values of the Enable register bits.

The return format can be selected by the

:FORMat:SREGister command. Response

data type is NR1 or NDN.

Remarks Bit definitions of the Standard Event register are shown in Table 3-2. All of the

enabled events of the Standard Event Status Enable register are logically ORed to

cause the Event Summary Bit (ESB) of the Status Byte register to be set.

The *CLS (clear status) command will not clear the enable register but it does clear

all bits in the event register.

The :STATus:PRESet command does not clear the bits in the Status Byte register.

See Also :FORMat:SREGister and :STATus:PRESet

1 ... 108 109 110 ... 326

No comments

Agilent Technologies B2902 Service Manual Page 109