Agilent Technologies B2902 Service Manual download pdf (Page 223)

Agilent B2900 SCPI Command Reference, Edition 2 4- 101

Subsystem Commands

[:SOURce]:DIGital:EXTernal[n]:TOUTput[:EDGE]:WIDTh

Parameter position Output trigger timing.

BEFore|AFTer|BOTH

(default). Parameter

data type is CPD.

type=BEFore enables trigger output at the beginning of arm, trigger, and device

actions (transient or acquire).

type=AFTer enables trigger output at the end of arm, trigger, and device actions

(transient or acquire).

type=BOTH enables trigger output at both beginning and end of arm, trigger, and

device actions (transient or acquire).

Query response response <newline>

response returns the present setting of output trigger timing, BEF, AFT or BOTH.

Response data type is CRD.

Example :DIG:EXT:TOUT:POS BEF

:SOUR:DIG:EXT2:TOUT:POS?

[:SOURce]:DIGital:EXTernal[n]:TOUTput[:EDGE]:W

IDTh

Sets the pulse width of the output trigger for the specified GPIO pin.

Syntax [:SOURce]:DIGital:EXTernal[n]:TOUTput[:EDGE]:WIDTh width

[:SOURce]:DIGital:EXTernal[n]:TOUTput[:EDGE]:WIDTh? [width]

Parameter width Pulse width. value (1E-5 to 1E-2, in seconds)|

MINimum|MAXimum|DEFault (default is 0.1 ms). Parameter

data type is NRf+. Query does not support width=value.

Query response width <newline>

width returns the present setting. If a parameter is specified, width returns the value

assigned to DEF, MIN, or MAX. Response data type is NR3.

Example :DIG:EXT:TOUT:WIDT 1E-5

:SOUR:DIG:EXT14:TOUT:WIDT?

[:SOURce]:DIGital:EXTernal[n]:TOUTput:TYPE

Selects the output trigger type for the specified GPIO pin.

1 ... 222 223 224 ... 326

No comments

Agilent Technologies B2902 Service Manual Page 223