Agilent Technologies B2902 Service Manual download pdf (Page 127)

Agilent B2900 SCPI Command Reference, Edition 2 4- 5

Subsystem Commands

:CALCulate:CLIMits:MODE

Example :CALC:CLIM:FAIL:DIG:DATA 64

:CALC2:CLIM:PASS:DIG?

:CALCulate:CLIMits:MODE

Sets the operation mode of the composite limit test to GRADing or SORTing.

Syntax :CALCulate[c]:CLIMits:MODE mode

:CALCulate[c]:CLIMits:MODE?

Parameter mode SORT (sorting)|GRAD (grading, default). Parameter data type

is CPD.

mode=GRAD performs limit tests for up to 12 test limits until a failure is detected.

See

Figure 2-11 for an example of a flowchart under the grading mode.

mode=SORT performs limit tests for up to 12 test limits until a pass is detected. See

Figure 2-10 for an example of a flowchart under the sorting mode.

A limit test is a pass/fail judgement performed during a composite limit test. It is

performed at the “Pass?” step in Figures

2-10 and 2-11.

Query response mode <newline>

mode returns GRAD or SORT. Response data type is CPD.

Example :CALC:CLIM:MODE SORT

:CALC2:CLIM:MODE?

:CALCulate:CLIMits:STATe

Enables or disables the composite limit test.

Syntax :CALCulate[c]:CLIMits:STATe mode

:CALCulate[c]:CLIMits:STATe?

Parameter mode 1|ON (default)|0|OFF. Parameter data type is boolean.

mode=1 or ON enables the composite limit test.

mode=0 or OFF disables the composite limit test.

Query response mode <newline>

1 ... 126 127 128 ... 326

No comments

Agilent Technologies B2902 Service Manual Page 127