Agilent Technologies B2902 Service Manual download pdf (Page 128)

4- 6 Agilent B2900 SCPI Command Reference, Edition 2

Subsystem Commands

:CALCulate:CLIMits:STATe:ANY?

mode is 0 or 1, and indicates that the composite limit test is off or on, respectively.

Response data type is NR1 or NDN.

Example :CALC:CLIM:STAT 1

:CALC2:CLIM:STAT?

:CALCulate:CLIMits:STATe:ANY?

Checks if the present composite limit test contains a limit test, which is a pass/fail

judgement. It is performed at the “Pass?” step in Figures

2-10 and 2-11.

Syntax :CALCulate[c]:CLIMits:STATe:ANY?

Query response status <newline>

status returns 0 or 1. Response data type is NR1.

0: No limit test exists.

1: At least one limit test exists.

Example :CALC2:CLIM:STAT:ANY?

:CALCulate:CLIMits:UPDate

Only for the GRAD composite limit test. Enables or disables the immediate result

output or update. See “Immediate?” shown in

Figure 2-11.

When enabled, the result output/update is executed immediately when the first

failure or all pass is detected. The result is the pass/fail bit pattern defined by the

:CALCulate:CLIMits:<FAIL|PASS>:DIGital[:DATA] command. If all pass is

detected, the pattern will be the pass pattern.

Syntax :CALCulate[c]:CLIMits:UPDate result

:CALCulate[c]:CLIMits:UPDate?

Parameter result END|IMMediate (default). Parameter data type is CPD.

result=IMM enables immediate result output.

result=END disables immediate result output.

Query response result <newline>

1 ... 127 128 129 ... 326

No comments

Agilent Technologies B2902 Service Manual Page 128