Agilent Technologies B2902 Service Manual download pdf (Page 42)

2- 2 Agilent B2900 SCPI Command Reference, Edition 2

Subsystem Command Summary

This chapter lists all of the SCPI subsystem commands for Agilent B2900 and

provides the summary information of the command.

• “Setting Source/Measure Unit”

“SOURce Subsystem,” for source setup

“SENSe Subsystem,” for measurement setup

“OUTPut Subsystem,” for using source output functions

“Source Output Ranges”

“Measurement Ranges”

• “Controlling Source/Measure Trigger”

“TRIGger Subsystem,” for triggering source output and measurement

• “Reading Source/Measure Data”

“FETCh Subsystem,” only for reading data

“FORMat Subsystem,” for data output format

“READ Subsystem,” for performing measurements

“MEASure Subsystem,” for a spot measurement

“CALCulate Subsystem,” for using limit test, calculation, and math functions

“TRACe Subsystem,” for using trace buffer

• “Using Advanced Functions”

“HCOPy Subsystem,” for getting screen dump

“DISPlay Subsystem,” for front panel display setup

“MMEMory Subsystem,” for managing data memory

“PROGram Subsystem,” for using program memory

“SYSTem Subsystem,” for using system functions

“STATus Subsystem,” for using status system

NOTE In the tables, Reset setting gives the initial setting or the default setting which is set

to the instrument when it is turned on or it receives the *RST command.

1 ... 41 42 43 ... 326

No comments

Agilent Technologies B2902 Service Manual Page 42