Agilent Technologies B2902 Service Manual download pdf (Page 283)

Agilent B2900 SCPI Command Reference, Edition 2 4- 161

Subsystem Commands

:TRIGger<:ACQuire|:TRANsient|[:ALL]>:TIMer

source=INT1 or INT2 selects a signal from the internal bus 1 or 2, respectively.

source=LANn selects a LXI trigger specified by the

:TRIGger<:ACQuire|:TRANsient|[:ALL]>:SOURce:LAN command.

source=EXTn selects a signal from the GPIO pin n, which is an input port of the

Digital I/O D-sub connector on the rear panel. n=1 to 14.

Query response response <newline>

response returns the present setting of trigger source, AINT, BUS, TIM, INT1,

INT2, LAN, or EXT1 through EXT14. Response data type is CRD.

Example :TRIG:SOUR EXT1

:TRIG2:TRAN:SOUR:SIGN?

:TRIGger<:ACQuire|:TRANsient|[:ALL]>:TIMer

Sets the interval of the TIMer trigger source for the specified device action.

Syntax :TRIGger[c]<:ACQuire|:TRANsient|[:ALL]>:TIMer interval

:TRIGger[c]<:ACQuire|:TRANsient>:TIMer? [interval]

:TRIGger[c][:ALL]:TIMer? interval

For <:ACQuire|:TRANsient|[:ALL]>, specify :ACQuire for measurement,

:TRANsient for source output, or :ALL for both device actions.

Parameter interval Interval, in seconds. value (1E-5 to 1E+5)|MINimum|

MAXimum|DEFault (default is 1E-5). Parameter data type is

NRf+. Query does not support interval=value.

Query response response <newline>

response returns the present setting of interval. If a parameter is specified, response

returns the value assigned to DEF, MIN, or MAX. Response data type is NR3.

Example :TRIG:TIM 2E-4

:TRIG2:TRAN:TIM?

1 ... 282 283 284 ... 326

No comments

Agilent Technologies B2902 Service Manual Page 283