Agilent Technologies B2902 Service Manual download pdf (Page 280)

4- 158 Agilent B2900 SCPI Command Reference, Edition 2

Subsystem Commands

:TRIGger<:ACQuire|:TRANsient|[:ALL]>:COUNt

:TRIG2:TRAN:BYP?

:TRIGger<:ACQuire|:TRANsient|[:ALL]>:COUNt

Sets the trigger count for the specified device action.

Syntax :TRIGger[c]<:ACQuire|:TRANsient|[:ALL]>:COUNt trigger_count

:TRIGger[c]<:ACQuire|:TRANsient>:COUNt? [trigger_count]

:TRIGger[c][:ALL]:COUNt? trigger_count

For <:ACQuire|:TRANsient|[:ALL]>, specify :ACQuire for measurement,

:TRANsient for source output, or :ALL for both device actions.

Parameter trigger_count Trigger count. value (1 to 100000)|MINimum|MAXimum|

DEFault (default is 1). Parameter data type is NRf+. Query does

not support trigger_count=value.

Arm count  Trigger count must be less than 100001.

Query response response <newline>

response returns the present setting of trigger count. If a parameter is specified,

response returns the value assigned to DEF, MIN, or MAX. Response data type is

NR1.

Example :TRIG:COUN 10

:TRIG2:TRAN:COUN?

:TRIGger<:ACQuire|:TRANsient|[:ALL]>:DELay

Sets the trigger delay for the specified device action.

Syntax :TRIGger[c]<:ACQuire|:TRANsient|[:ALL]>:DELay delay

:TRIGger[c]<:ACQuire|:TRANsient>:DELay? [delay]

:TRIGger[c][:ALL]:DELay? delay

For <:ACQuire|:TRANsient|[:ALL]>, specify :ACQuire for measurement,

:TRANsient for source output, or :ALL for both device actions.

1 ... 279 280 281 ... 326

No comments

Agilent Technologies B2902 Service Manual Page 280