Agilent Technologies B2902 Service Manual download pdf (Page 204)

4- 82 Agilent B2900 SCPI Command Reference, Edition 2

Subsystem Commands

:SENSe:DATA?

value for resistance measurement: See Table 2-9. This is available for the resistance

measurements set to the AUTO mode which is selected by the

:SENSe:RESistance:MODE command.

range=UP sets the next higher measurement range.

range=DOWN sets the next lower measurement range.

Query response range <newline>

range returns the present setting of the measurement range. If a parameter is

specified, range returns the value assigned to DEF, MIN, or MAX. Response data

type is NR3.

Example :SENS:CURR:RANG:UPP 1

:SENS2:CURR:DC:RANG:UPP?

:SENSe:DATA?

Returns the array data which contains all of the current measurement data, voltage

measurement data, resistance measurement data, source output setting data, status

data, or time data specified by the

:FORMat:ELEMents:SENSe command. The data

is not cleared until the :INITiate, :MEASure, or :READ command is executed.

Syntax :SENSe[c]:DATA? [offset[, size]]

Parameter offset Indicates the beginning of the data received. n|CURRent|STARt

(default). Parameter data type is NR1 or CPD.

offset=n specifies the n+1th data. n is an integer, 0 to maximum

(depends on the buffer state).

offset=CURR specifies the present data position.

offset=STAR specifies the top of the data buffer. Same as

offset=0.

size Number of data to be received. 1 to maximum (depends on the

buffer state). Parameter data type is NR1. If this parameter is

not specified, all data from offset is returned.

Query response response <newline>

response returns the array data specified by the :FORMat:ELEMents:SENSe

command. Response data type is NR3. See “Data Output Format” on page 1-12.

1 ... 203 204 205 ... 326

No comments

Agilent Technologies B2902 Service Manual Page 204