Agilent Technologies B2902 Service Manual download pdf (Page 132)

4- 10 Agilent B2900 SCPI Command Reference, Edition 2

Subsystem Commands

:CALCulate:LIMit:COMPliance:DIGital[:DATA]

:CALCulate[c]:FEED?

Parameter type Data type. MATH|RESistance|CURRent|VOLTage (default).

Parameter data type is CPD.

type=VOLT specifies the voltage measurement data.

type=CURR specifies the current measurement data.

type=RES specifies the resistance calculation data given by the following formula.

Resistance=Vmeas/Imeas

Where, Vmeas is the voltage measurement data, and Imeas is the current

measurement data.

type=MATH specifies the data given by a math expression. The math expression

must be specified before the :CALC:FEED MATH command is executed.

An existing math expression can be specified by the

:CALCulate:MATH[:EXPRession]:NAME command.

A new math expression can be defined by the

:CALCulate:MATH[:EXPRession]:NAME and

:CALCulate:MATH[:EXPRession][:DEFine] commands.

Query response type <newline>

type returns the present setting of data type, MATH, RES, CURR, or VOLT.

Response data type is CRD.

Example :CALC:FEED MATH

:CALC2:FEED?

:CALCulate:LIMit:COMPliance:DIGital[:DATA]

Defines the bit pattern used to indicate a failure of the compliance status check

specified by m. It must be entered in the format set by the

:FORMat:DIGital

command.

Syntax :CALCulate[c]:LIMit[m]:COMPliance:DIGital[:DATA] bit_pattern

:CALCulate[c]:LIMit[m]:COMPliance:DIGital[:DATA]?

Parameter bit_pattern 0 (default setting in decimal expression) to 16383. Parameter

data type is NR1 or NDN.

1 ... 131 132 133 ... 326

No comments

Agilent Technologies B2902 Service Manual Page 132