Agilent Technologies B2902 Service Manual download pdf (Page 155)

Agilent B2900 SCPI Command Reference, Edition 2 4- 33

Subsystem Commands

:FORMat:BORDer

FORMat Subsystem

:FORMat:BORDer

This command is effective when the data output format is set to the IEEE-754

binary format by using the

:FORMat[:DATA] command. This command sets the

byte order of binary output data.

Syntax :FORMat:BORDer byte_order

:FORMat:BORDer?

Parameter byte_order NORMal (default)|SWAPped. Parameter data type is CPD.

byte_order=NORMal sets the normal byte order. For the IEEE-754 single precision

format, byte 1 to byte 4 are sent in this order. For the IEEE-754 double precision

format, byte 1 to byte 8 are sent in this order.

byte_order=SWAPped sets the reverse byte order. For the IEEE-754 single precision

format, byte 4 to byte 1 are sent in this order. For the IEEE-754 double precision

format, byte 8 to byte 1 are sent in this order.

Query response byte_order <newline>

byte_order returns NORM or SWAP. Response data type is CRD.

Example :FORM:BORD SWAP

:FORM:BORD?

:FORMat[:DATA]

Sets the data output format. See “Data Output Format” on page 1-12.

Syntax :FORMat [:DATA] format

:FORMat [:DATA]?

Parameter format Data output format. Parameter data type is CPD.

ASCii|REAL,32|REAL,64. RERL,64 is only for the default

language mode set by the :SYST:LANG “DEF” command.

1 ... 154 155 156 ... 326

No comments

Agilent Technologies B2902 Service Manual Page 155