Agilent Technologies N8201A Service Manual download pdf (Page 98)

100

101

98 Agilent N8201A Performance Downconverter Synthetic Instrument Module, 250 kHz to 26.5 GHz

4 BW/Avg

Average

Initiates a digital averaging routine that averages the trace points in a number of successive

sweeps, resulting in trace “smoothing.” You can select the number of sweeps (average

number) with the keyboard. Increasing the average number further smooths the trace. To

select the type of averaging used, press BW/Avg, Avg/VBW Type.

Averaging restarts when any of the following occurs:

• a new average number is entered.

• any measurement related parameter (for example, center frequency) is changed.

• Restart is pressed.

• Single Sweep is pressed.

In single sweep, the specified number of averages is taken, then the sweep stops.

In continuous sweep, the specified number of averages is taken, then the

averaging continues, with each new sweep averaged in with a weight of

and the old average reduced by multiplying it by

To turn off averaging, press Average (Off).

Key Path: BW/Avg

Saved State: Saved in Instrument State

Factory Preset: Off, 100 averages

Range: Count: 1 to 8192

Remote Commands:

[:SENSe]:AVERage[:STATe] OFF|ON|0|1

[:SENSe]:AVERage[:STATe]?

[:SENSe]:AVERage:COUNt <integer>

[:SENSe]:AVERage:COUNt?

[:SENSe]:AVERage:CLEar

Remote Command Notes:

For valid average data, you must restart the trace at the beginning of a sweep. To do this

remotely, first abort (:ABORT) the sweep and then initiate a single sweep (:INIT:CONT

OFF).

Average Number

---------------------------------------

Average Number 1–

Average Number

------------------------------------------------

1 2 ... 93 94 95 96 97 98 99 100 101 102 103 ... 621 622

Comments to this Manuals

No comments

Agilent Technologies N8201A Service Manual Page 98

Comments to this Manuals

Related products and manuals for Video converters Agilent Technologies N8201A