Agilent Technologies 4294A Service Manual download pdf (Page 330)

100

101

330 Chapter 16

GPIB Command Reference

LIMSADD

Syntax LIMSADD [<numeric>]

Description In the creation/edit of the limit line table, adds a new segment, changes the edit target

segment to the added segment, and starts edit. The position where a segment is added is as

follows:

• If a segment is specified:

Added in the line below the specified segment.

• If no segment is specified:

Added in the line below the segment specified as the edit target (set with the

“LIMSEGM” command on page 333).

The number of the added segment is a value of the specified segment number (if no

segment is specified, the edit target segment number before the execution of the command)

plus 1, and the number of each following segment also increases by 1.

After the completion of the parameter setting of the segment, execute the “LIMSDON”

command on page 331 to finish the edit work. After executing this command and the

“LIMSEDI” command on page 332 (to start segment edit), executing this command,

without executing the “LIMSDON” command, causes an error and the command is

ignored.

If the creation/edit of the limit line table has not been started, executing this command

automatically starts table creation/edit and then adds a segment. (No query)

Parameters

If the specified parameter is out of the allowable setting range, the minimum value (if the

lower limit of the range is not reached) or the maximum value (if the upper limit of the

range is exceeded) is set.

Corresponding

key

[System] - LIMIT TEST - EDIT LIMIT LINE - ADD 

Description Segment number immediately before the addition and insertion

location

Range 1 to the number of the segments in the limit line table

Resolution 1

1 2 ... 325 326 327 328 329 330 331 332 333 334 335 ... 517 518

Comments to this Manuals

No comments

Agilent Technologies 4294A Service Manual Page 330

Comments to this Manuals

Related products and manuals for Multimeters Agilent Technologies 4294A