Agilent Technologies 4294A Service Manual download pdf (Page 39)

100

101

Chapter 3 39

Setting Measurement Conditions

Setting a Sweep Condition

1. Chapter Title

2. Chapter Title 3. Setting Measurement

4. Chapter Title

5. Chapter Title

Conditions

Setting a Sweep Condition

Setting a sweep parameter

Choose a sweep parameter from among the oscillator frequency, oscillator level, and dc

bias level. To set the parameter, use the command given below.

• “SWPP” on page 449

The following settings for the sweep condition will be stored in memory for each

parameter chosen above.

Setting a sweep range

There are two ways to set the sweep range: by specifying the central value and span of the

sweep range or by specifying the start point and endpoint of the sweep range. To specify

the central value and the span, use the commands given below.

• “CENT” on page 277

• “SPAN” on page 442

To specify the start point and the endpoint, use the commands given below.

• “STAR” on page 444

• “STOP” on page 446

To set the number of measurement points within the sweep range, use the command given

below.

• “POIN” on page 401

Setting sweep time

To set the sweep time, use the command given below.

• “SWET” on page 448

You can set the point delay time (waiting time for measurement start at each measurement

point) and the sweep delay time (waiting time for sweep start at each sweep). To set them,

use the commands given below.

• “PDELT” on page 397

• “SDELT” on page 426

Setting a sweep direction

To set the sweep direction, use the command given below.

• “SWED” on page 448

Setting a sweep type

To set the sweep type, use the command given below.

• “SWPT” on page 449

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 517 518

Comments to this Manuals

No comments

Agilent Technologies 4294A Service Manual Page 39

Comments to this Manuals

Related products and manuals for Multimeters Agilent Technologies 4294A