Agilent Technologies 4294A Service Manual download pdf (Page 391)

100

101

Chapter 16 391

GPIB Command Reference

OUTPRESO?

16. GPIB

Command Reference

( O - R )

OUTPRESO?

Syntax OUTPRESO?

Description If the sweep parameter is frequency and the measurement parameter is |Z|-θ, within the

waveform analysis range specified with the

“ANARANG” command on page 267,

analyzes the resonant point and reads out the result. If the sweep parameter is not

frequency or if the measurement parameter is not |Z|-θ, executing this command causes an

error and all readouts are 0. (Query only)

Query response {numeric 1},{numeric 2},{numeric 3},{numeric 4}<newline><^END>

The readouts are as follows:

{numeric 1}: Value of Z

(resonant impedance).

{numeric 2}: Value of f

(resonant frequency).

{numeric 3}: Value of Z

(anti-resonant impedance).

{numeric 4}: Value of f

(anti-resonant frequency).

This command searches for points of phase 0° within the analysis range from the left edge,

and defines the 1st detected point as the resonant point and the 2nd detected point as the

anti-resonant point. Even if 3 or more phase 0° points are detected, only the first 2 points

are used. If only 1 phase 0° point is detected, 0 is read out for both Z

and f

. If no phase 0°

point is detected, 0 is read out for all the parameters.

Figure 16-5 Analyzed parameters

Corresponding

key

No front panel key is available to execute this function.

1 2 ... 386 387 388 389 390 391 392 393 394 395 396 ... 517 518

Comments to this Manuals

No comments

Agilent Technologies 4294A Service Manual Page 391

Comments to this Manuals

Related products and manuals for Multimeters Agilent Technologies 4294A