Agilent Technologies 4294A Service Manual download pdf (Page 358)

100

101

358 Chapter 16

GPIB Command Reference

MKRPRM

Syntax MKRPRM <numeric>[HZ|MHZ|V|A]

MKRPRM?

Description For the active trace (set with the “TRAC” command on page 457), moves the marker to the

specified sweep parameter value. In the coupled marker mode (set with the “MKRCOUP”

command on page 352), regardless of the active trace setting, moves the markers on both

the A and B traces. If this command is executed as Query, it reads out the sweep parameter

value of the marker position.

If the Δ marker mode is on, the marker moves the distance of the specified sweep

parameter value relative to the Δ marker position. Therefore, specify the position to which

you want to move the marker as the difference from the Δ marker. The readout, when this

command is executed as query, is also the difference value from the Δ marker.

If the marker function is off, executing this command causes an error and the command is

ignored.

Parameters

If the specified parameter is out of the allowable setting range, the minimum value (if the

lower limit of the range is not reached) or the maximum value (if the upper limit of the

range is exceeded) is set.

Query response {numeric}<newline><^END>

Corresponding

key

[Marker]

MKRREF

Syntax MKRREF

Description For the active trace (set with the “TRAC” command on page 457), sets the measurement

parameter value at the marker position (regardless of on/off of the Δ marker mode, the

marker readout when the Δ marker mode is off) as the reference value. If the marker

function is off, executing this command causes an error and the command is ignored. (No

query)

Corresponding

key

[Scale Ref] - MKR → REFERENCE

Description Position to which you want to move the marker

Range “Sweep start value” to “sweep stop value”

Initial value 0

Unit Varies depending on the sweep parameter (refer to the explanation

of unit in

“CENT” on page 277).

Resolution Varies depending on the sweep parameter (refer to the explanation

of resolution in

“CENT” on page 277).

1 2 ... 353 354 355 356 357 358 359 360 361 362 363 ... 517 518

Comments to this Manuals

No comments

Agilent Technologies 4294A Service Manual Page 358

Comments to this Manuals

Related products and manuals for Multimeters Agilent Technologies 4294A