Agilent Technologies 4294A Service Manual download pdf (Page 494)

494 Appendix D

Error messages

Error number: 37

key, CALC PARMS key, or CALECPARA command) was executed, because the number of

points (NOP) within the sweep range (if the partial search function is on, within the

specified search range) is 2, they cannot be calculated. Set the number of points within the

sweep range (if the partial search function is on, within the specified search range) to 3 or

more.

37 DISPLAY BUFFER IS FULL

The use of the DRAW or MOVE command of HP Instrument BASIC made 4294A’s

display buffer full. Further write to the display buffer is impossible.

48 PHASE LOCK LOOP UNLOCKED

Anomalies in the 4294A’s internal circuit were detected (phase lock loop was not locked).

The instrument needs adjustment or repair. Contact your local Agilent Technologies sales

office or the company you purchased this instrument from.

54 TOO MUCH DATA

When data was sent from the controller to the 4294A in the FORM2, FORM3, or FORM5

data transfer format, the amount of the sent binary data was too large, or data items

exceeded the number of points (NOP) set in the 4294A. Set data to be sent or the number of

points of the 4294A correctly.

55 NOT ENOUGH DATA

When data was sent from the controller to the 4294A in the FORM2, FORM3, or FORM5

data transfer format, the amount of the sent binary data was too small, or data items did not

reach the number of points (NOP) set in the 4294A. Set data to be sent or the number of

points of the 4294A correctly.

64 TOO MANY SEGMENTS

You attempted to add segments whose quantity exceeded the maximum number (18) to the

limit line table. The number of segments you can set in the limit line table is up to 18.

74 CURRENT EDITING SEGMENT SCRATCHED

During the edit of a segment in the list sweep table or limit line table, a key or command

not related to edit of the table was executed, and the segment that was being edited became

invalid. To avoid this, press "done key" in the segments menu, SDON (command to finish

the edit of a list sweep segment), or LIMSDON (command to finish the edit of a limit

segment), and then perform other settings.

75 COMMAND IGNORED -SEGMENT NOT DONE YET

During the edit of a segment in the list sweep table or limit line table, an inappropriate edit

command (EDIT LIML, EDITLIST, LIMCLEL, LIMSEDI, LIMSADD, LIMSDEL,

SLEL, SEDI, SADD, SEGM) was sent and, as a result, the command was ignored. If

necessary, execute SDON (command to finish the edit of a list sweep segment), or

LIMSDON (command to finish the edit of a limit segment) to finish the edit of the segment,

and then perform the setting.

77 TOO MANY SEGMENTS OR POINTS

During the edit of the list sweep table, you attempted to set a value that exceeded the

maximum of segments (18), the maximum number of points per segment (201), or the

maximum number of total points in all segments (801). Set a value of the number of

segments or the number of points that does not exceed the maximum value.

82 CAN'T CHANGE -ANOTHER CONTROLLER ON BUS

1 2 ... 489 490 491 492 493 494 495 496 497 498 499 ... 517 518

Comments to this Manuals

No comments

Agilent Technologies 4294A Service Manual Page 494

Comments to this Manuals

Related products and manuals for Multimeters Agilent Technologies 4294A