Agilent Technologies 4294A Service Manual download pdf (Page 387)

100

101

Chapter 16 387

GPIB Command Reference

OUTPMKR?

16. GPIB

Command Reference

( O - R )

OUTPMKR?

Syntax OUTPMKR?

Description For the active trace (set with the “TRAC” command on page 457), reads out the

measurement parameter value and sweep parameter value at the marker position. If the

marker function is off, executing this command causes an error and the read out values are

invalid.(Query only)

Query response {numeric 1},{numeric 2},{numeric 3}<newline><^END>

Readouts are as follows:

{numeric 1}: Readout of the measurement parameter value at the marker position. If

the measurement parameter is a scalar value (for other than

COMPLEX Z-Y), the measurement parameter value is read out. If the

measurement parameter is a vector value (for COMPLEX Z-Y), the

readout is as follows:

• If the polar chart format is selected, the amplitude is read out.

• If the complex plane format is selected, resistance (for trace A) or

conductance (for trace B) is read out.

{numeric 2}: Subsidiary readout of the measurement parameter value at the marker

position. If the measurement parameter is a scalar value (for other than

COMPLEX Z-Y), 0 is always read out. If the measurement parameter

is a vector value (for COMPLEX Z-Y), the readout is as follows:

• If the polar chart format is selected, the phase is read out.

• If the complex plane format is selected, reactance (for trace A) or

susceptance (for trace B) is read out.

{numeric 3}: Sweep parameter value at the marker position.

Corresponding

key

No front panel key is available to execute this function.

1 2 ... 382 383 384 385 386 387 388 389 390 391 392 ... 517 518

Comments to this Manuals

No comments

Agilent Technologies 4294A Service Manual Page 387

Comments to this Manuals

Related products and manuals for Multimeters Agilent Technologies 4294A