Agilent Technologies 4294A Service Manual download pdf (Page 498)

498 Appendix D

Error messages

Error number: 114

Though you attempted to display the list of files and directories on a floppy disk on the

softkey label by executing the recall ([Recall]) key, file resave (RE-SAVE FILE) key, file

deletion (PURGE FILE) key, directory change (CHANGE DIRECTORY) key, or file copy

(COPY FILE) key, no file or directory corresponding to the execution of the key was on

the floppy disk.

114 CAN'T SAVE GRAPHICS WHEN COPY IN PROGRESS

You commanded to save the graphics screen during the execution of copying (outputting to

a printer), but the graphics screen cannot be saved during output to a printer.

116 NO STATE/DATA FILES ON MEMORY

Though you attempted to display the list of files and directories on a volatile memory disk

or nonvolatile memory disk (flash memory) on the softkey label by executing the recall

([Recall]) key, file resave (RE-SAVE FILE) key, file deletion (PURGE FILE) key,

directory change (CHANGE DIRECTORY) key, file copy (COPY FILE) key, and so on,

no file or directory corresponding to the execution of the key was on the volatile memory

disk or nonvolatile memory disk (flash memory).

118 DEVICE TYPE IS NOT DOS

The execution of write access to the mass storage could not be executed because the format

type of the mass storage was not DOS.

124 LIST TABLE EMPTY OR INSUFFICIENT TABLE

When the list sweep table was empty or insufficient, you attempted to select LIST as the

sweep type (command: SWPT

LIST) and, as a result, the command was ignored. Before

selecting the list sweep as the sweep type, set the list sweep table correctly.

130 CAN'T CHANGE ON ZERO SPAN

During the execution of the list sweep when the sweep span of each segment was zero, you

attempted to change the list sweep span (integrated total span of individual segments

specified as the horizontal axis of the graph for the list sweep) to the single span (the way

to specify a linear frequency axis for the horizontal axis of the graph whose left edge and

right edge are the minimum frequency and the maximum frequency within all segments)

using the LIST SPAN [ ] key or the LISPAN SINGLE command and, as a result, the

command was ignored. When executing the list sweep while the sweep span of each

segment being zero, the list sweep span is automatically set to the segment span and cannot

be changed.

131 FREQUENCY SWEEP ONLY

When a sweep parameter other than the frequency was specified, you attempted to execute

an equivalent circuit analysis command (CALECPARA and so on). You can execute the

equivalent circuit analysis only when the sweep parameter is the frequency.

132 LIST SWEEP ONLY

When a sweep type other than the list sweep was specified, you attempted to execute a

command to specify all segments (entire sweep range) as the search range setting

(SEARNG FULL) or a command to specify a certain segment as the search target

(SEGMNUM <value>) and, as a result, the command was ignored. Before setting the

search range for the list sweep, specify the list sweep as the sweep type (command: SWPT

LIST).

133 CAN'T CHANGE ON LIST SWEEP

When the sweep type was set to the list sweep, you attempted to execute a command to

1 2 ... 493 494 495 496 497 498 499 500 501 502 503 ... 517 518

Comments to this Manuals

No comments

Agilent Technologies 4294A Service Manual Page 498

Comments to this Manuals

Related products and manuals for Multimeters Agilent Technologies 4294A