Agilent Technologies 4294A Service Manual download pdf (Page 495)

Appendix D 495

Error messages

Error number: 83

1. Chapter Title

2. Chapter Title D. Error messages

4. Chapter Title

5. Chapter Title

When an active controller was on the same GPIB bus, you attempted to set the 4294A as a

system controller. Unless another active controller is removed from the same GPIB bus,

you cannot set the 4294A as a system controller.

83 NOT VALID FOR COMPLEX MEASUREMENT

When the COMPLEX Z-Y measurement parameter (that is, complex parameter

measurement) is selected, a command to execute one of the following is sent. As a result,

the command is ignored.

• Setting or reading an offset value in the trace calculation function (DATOVAL

command)

• Assigning the main marker to the offset value in the trace calculation function

(MKROFS command)

• Selecting DELTA % in the trace calculation function (DISP DELP command)

When making the above settings, first select a measurement parameter other than

COMPLEX Z-Y.

84 NOT VALID FOR SCALAR MEASUREMENT

When a measurement parameter other than COMPLEX Z-Y (that is, scalar parameter

measurement) is selected, a command to execute one of the following is sent. As a result,

the command is ignored.

• Setting the secondary measurement parameter value of the fixed Δ marker

(DMKRAUV command)

• Selecting DATA/MEM in the trace calculation function (DISP DDVM command)

When making the above settings, first select the COMPLEX Z-Y measurement parameter.

85 FORMAT NOT VALID FOR COMPLEX MEASUREMENT

When COMPLEX Z-Y (i.e., complex parameter measurement) was selected as a

measurement parameter, you attempted to select a display format not available for the

measurement parameter, for example, the linear scale format (FMT LINY command) and,

as a result, the command was ignored. When COMPLEX Z-Y is selected as a measurement

parameter, set the display format to the complex plane display format (command: FMT

COMP) or the polar coordinates display format (command: FMT

POLA).

86 FORMAT NOT VALID FOR SCALOR MEASUREMENT

When a measurement parameter other than COMPLEX Z-Y (i.e., scalar parameter

measurement) was selected, you attempted to select a display format not available for the

measurement parameter, for example, the complex plane display format (command: FMT

COMP) and, as a result, the command was ignored. When a measurement parameter other

than COMPLEX Z-Y is selected, select a display format from the linear scale format

(command: FMT LINY), the log scale format (command: FMT LOGY), or the percent

format (command: FMT PERC).

87 THETA MEASUREMENT NOT SELECTED

When the setting of the phase (q) was not active as a measurement parameter, you

attempted to execute a command to set the phase unit (PHAU DEG or PHAU RAD) or a

command to set the phase expansion display (EXPP ON or EXPP OFF) and, as a result, the

command was ignored. The active status of the phase (θ) setting means:

•|Z|-θ or |Y|-θ is selected as a measurement parameter and trace B is active.

1 2 ... 490 491 492 493 494 495 496 497 498 499 500 ... 517 518

Comments to this Manuals

No comments

Agilent Technologies 4294A Service Manual Page 495

Comments to this Manuals

Related products and manuals for Multimeters Agilent Technologies 4294A