Agilent Technologies 4294A Service Manual download pdf (Page 505)

Appendix D 505

Error messages

Error number: -256

1. Chapter Title

2. Chapter Title D. Error messages

4. Chapter Title

5. Chapter Title

correctly. This message is displayed, for example, when you specifies the floppy disk drive

as the storage device but no floppy disk is set into the drive (correctly).

-256 File name not found

The specified filename was not found and, as a result, the command was not executed

correctly. This message is displayed, for example, when you attempt to read/write a file

that does not exist on the disk.

-257 FILE NAME ERROR

There was an error in the filename and, as a result, the command was not executed

correctly.

This message is displayed, for example, when you attempt to copy a file using the same

filename.

-258 Media protected

You attempted to save/delete data to/from the storage device or initialize the media, but the

media was write-protected, and, as a result, the operation could not be executed. This

message is displayed, for example, when you have specified the floppy disk drive as the

storage device and a floppy disk is write-protected. If necessary, disable the

write-protection for the floppy disk.

-280 Program error

A program error.

An error occurred in a downloaded program. An error other than -281 to -289 occurred.

-281 Cannot create program

Programs cannot be created. Insufficient memory is suspected.

-282 Illegal program name

The program name is illegal. This message is displayed, for example, when you attempt to

delete a program name that does not exist, define an existing program name again, or refer

to a program that does not exist.

-283 Illegal variable name

The variable name is illegal. This message is displayed when you attempt to refer to a

variable that does not exist.

-284 Program currently running

The program is running.

This message is displayed when you attempt to perform an operation that cannot be

executed during the execution of a program. For example, when you attempt to delete a

running program.

-285 Program syntax error

A program syntax error.

A program syntax error occurred in the downloaded program.

-286 Program runtime error

An error occurred while an HP Instrument BASIC program is being executed. To obtain

detailed information on the occurred error, use theERRM$ or ERRM command of HP

Instrument BASIC.

1 2 ... 500 501 502 503 504 505 506 507 508 509 510 ... 517 518

Comments to this Manuals

No comments

Agilent Technologies 4294A Service Manual Page 505

Comments to this Manuals

Related products and manuals for Multimeters Agilent Technologies 4294A