Agilent Technologies 4294A Service Manual download pdf (Page 440)

100

101

440 Chapter 16

GPIB Command Reference

SMKRPRM{1-7}

Syntax SMKRPRM{1|2|3|4|5|6|7} <numeric>[HZ|MHZ|V|A]

SMKRPRM{1|2|3|4|5|6|7}?

Description For the active trace (set with the “TRAC” command on page 457), moves a sub marker

(marker number 1-7) to the position of the specified sweep parameter value. In the coupled

marker mode (set with the

“MKRCOUP” command on page 352), regardless of the active

trace setting, moves the sub marker on both the A and B traces. If this command is

executed as Query, it reads out the sweep parameter value of the sub marker position.

If the Δ marker mode is on, the sub marker moves the distance of the specified sweep

parameter value relative to the Δ marker. Therefore, specify the position where you want to

move the sub marker by the difference from the Δ marker. Also, the readout, when

executed as query, is the difference value from the Δ marker.

If the sub marker is off, executing this command causes an error and the command is

ignored.

Parameters

If the specified parameter is out of the allowable setting range, the minimum value (if the

lower limit of the range is not reached) or the maximum value (if the upper limit of the

range is exceeded) is set.

Query response {numeric}<newline><^END>

Corresponding

key

No front panel key is available to execute this function.

Description Position where you want to move the sub marker

Range “Sweep start value” to “sweep stop value”

Initial value 0

Unit Varies depending on the sweep parameter (refer to the explanation

of unit in

“CENT” on page 277).

Resolution Varies depending on the sweep parameter (refer to the explanation

of resolution in

“CENT” on page 277).

1 2 ... 435 436 437 438 439 440 441 442 443 444 445 ... 517 518

Comments to this Manuals

No comments

Agilent Technologies 4294A Service Manual Page 440

Comments to this Manuals

Related products and manuals for Multimeters Agilent Technologies 4294A