Agilent Technologies 4294A Service Manual download pdf (Page 373)

Chapter 16 373

GPIB Command Reference

OUTPCALC{1-3}?

16. GPIB

Command Reference

( O - R )

OUTPCALC{1-3}?

Syntax OUTPCALC{1-3}?

Description Reads out the OPEN/SHORT/LOAD data for user calibration. Use the “OUTPCALC1”

command to read out the OPEN data (G-B); the “OUTPCALC2” command, the SHORT

data (R-X); the “OUTPCALC3” command, the LOAD data (R-X). (Query only)

Query response {numeric 1},{numeric 2},..,{numeric NOP×2-1},{numeric NOP×2}<newline><^END>

Reads out the real part and the imaginary part of each measurement point value (complex

number) separately. Where, NOP is the number of points (for user measurement points) or

100 (for fixed measurement points), and n is an integer between 1 and NOP.

{numeric n×2-1}: Value of the n-th measurement point (real part)

{numeric n×2}: Value of the n-th measurement point (imaginary part)

Corresponding

key

No front panel key is available to execute this function.

OUTPCERR?

Syntax OUTPCERR?

Description If the sweep parameter is frequency and the measurement parameter is |Z|-θ, within the

waveform analysis range specified with the

“ANARANG” command on page 267, obtains

the parameters of a ceramic resonator and reads out the results. If the sweep parameter is

not frequency or if the measurement parameter is not |Z|-θ, executing this command causes

an error and all readouts are 0. (Query only)

Query response {numeric 1},{numeric 2},{numeric 3},{numeric 4},{numeric 5},{numeric 6},{numeric 7}<newline><^END>

The readouts are as follows:

{numeric 1}: Value of Z

(resonant impedance).

{numeric 2}: Value of f

(resonant frequency).

{numeric 3}: Value of Z

(anti-resonant impedance).

{numeric 4}: Value of f

(anti-resonant frequency).

{numeric 5}: Value of Rpl

(the maximum value of the left-side ripple (the sweep

parameter difference between the peak and the left adjacent negative

peak) within the range to the left of the resonant point within the

waveform analysis range).

{numeric 6}: Value of Rpl

(the maximum value of the right-side ripple (the sweep

parameter difference between the peak and the right adjacent negative

peak) within the range between the resonant point and the

anti-resonant point within the waveform analysis range).

{numeric 7}: Rpl

(the maximum value of the left-side ripple within the range to the

right of the resonant point within the waveform analysis range).

1 2 ... 368 369 370 371 372 373 374 375 376 377 378 ... 517 518

Comments to this Manuals

No comments

Agilent Technologies 4294A Service Manual Page 373

Comments to this Manuals

Related products and manuals for Multimeters Agilent Technologies 4294A