Agilent Technologies 4294A Service Manual download pdf (Page 376)

100

101

376 Chapter 16

GPIB Command Reference

OUTPDC?

Syntax OUTPDC?

Description In the dc bias level monitor function, if monitoring voltage or current is enabled (VOLT or

CURR has been specified with the

“BMON” command on page 272), reads out the dc bias

level voltage or current monitor value at all measurement points. (Query only)

Query response {numeric 1},{numeric 2},..,{numeric NOP}<newline><^END>

Where, NOP is the number of points.

If the oscillator level monitor function is set to off, the readout are invalid.

Corresponding

key

No front panel key is available to execute this function.

OUTPDCP?

Syntax OUTPDCP? <numeric 1>

Description In the dc bias level monitor function, if monitoring voltage or current is enabled (VOLT or

CURR has been specified with the

“BMON” command on page 272), reads out the dc bias

level voltage or current monitor value of the specified measurement point. (Query only)

Parameters

If the specified parameter is out of the allowable setting range, the minimum value (if the

lower limit of the range is not reached) or the maximum value (if the upper limit of the

range is exceeded) is set.

Query response {numeric 2}<newline><^END>

If the oscillator level monitor function is set to off, the readout is invalid.

Corresponding

key

No front panel key is available to execute this function.

Description Number of the measurement point you want to read out (the

number assigned in order from the left edge assuming that the

number of the leftmost measurement point is 1)

Range 1 to the number of points

Resolution 1

{numeric 2}

Description Voltage or current monitor value of the dc bias level

1 2 ... 371 372 373 374 375 376 377 378 379 380 381 ... 517 518

Comments to this Manuals

No comments

Agilent Technologies 4294A Service Manual Page 376

Comments to this Manuals

Related products and manuals for Multimeters Agilent Technologies 4294A